3L Kneader/JDL-30 Single screw rubber sheet extrusion line
Ⅰ. The technical parameters of the system unit
1), Machine color: The main machine: the company standard color; Electric cabinet for: computer gray color; Guard cover: yellow
2), Extrusion process:3L Kneader---- conical twin screw extruder----JD-30 Single screw extruder----Mould interface----300mm rubber mold----three-roll calendars---- Mold temperature controller---- Laminating system---- Double-winding
3)，Processing materials: PP sheet
Capacity: 4-8kg/h
Ⅱ. The technical configuration
1)、Kneader main technical parameters
A. Mixing tank: 3L
B. Rachis : Clover. Wear resistant ring using special alloy material.
C. Speed: front axle :32 r.p.m rear axle 25r.p.m
D. Power plant : 1 main motor: 7.5KW,6P, 380V, 50HZ,AC
2 Motor: 7.5KW 4P, 380V, 50HZ,AC.
E. Lubrication : 1.rachis bearing lubricated with grease.
2. reduction chassis with oil bath splash lubrication.
F. Unloading mode : Flip type unloading.
G. Seal : Mechanical seal.
H. Temperature control : Electric heating, automatic heating below the set temperature, reaches the set temperature stops heating automatically or through compulsory cooling water.
I. Motor direction : When machine operators face the discharge side standing on the right side of the machine, motor.
J. Host transmission system : Through the belt pulley to drive the power of indirect drive to the reduction gear box, the gear box and the link gear coupling by rachis, rachis before through the gear drive after the bite.
K. Flip motor drive system : Through direct coupling transmits power to the
worm, the worm gear and worm drive.
L. Main motor protection : When the main motor current exceeds the current table
setting current, pressurizing automatic rising, the
current is normal and automatic falling gland.